#!#
! "
Reassembling: Position the belt under the
back extrusion of the carriage.
Make sure that you correctly reconnect the
trailing cable page 6Ć35.
After reassembling, make sure that you check
the carriageĆtoĆmedia distance page 7Ć11.
Calibration: After having reassembled the
plotter, perform the black cartridgeĆalignment.
(Details User's Guide.)
! !
! #
Reassembling: Clip the belt to the carriage,
using the same part of the belt as was
originally used. Also, match the vertical lines
on the belt with the vertical grooves on the
carriage. The horizontal lines on the belt face
outwards.
To Next Page
Loading...
