6Ć13 Removal and ReplacementC4699Ć90000
Removing the Electronics
Module
The electronics module is a fieldĆreplaceable
part. You do not need to open it. If it is faulty,
exchange it for a new one.
Remove the right endĆcover page 6Ć10.
Disconnect the frontĆpanel assembly from
the main PCA page 6Ć12.
Unscrew the cover plate at the back of the
plotter, and remove it.
Torx-10
or
Flat
Remove the indicated two screws from
the back cover.
Torx-20
Remove the indicated screw from the
floor of the electronics module.
Torx-20
At the back of the plotter, ensure that the
two small wire clamps of the parallel port
are positioned flush against the
electronics module
Push the electronics module towards the
front of the plotter.
To Next Page
Loading...
