Media Type
Read Settings
Print Quality
Align Cartridges
Cancel
Replot
& #!"
&
! # ! # "#
If you clear the calibration parameters, you will then need to perform the plotter
calibrations. (Details chapter 7.) Clearing the EEROM also resets the factory
spittoon value to 0% used. Keep in mind that the value printed on the service
configuration plot may greatly underestimate the amount of ink in the spittoon.
! $"# # !$ !# !#!"
$" " ""
" "
Read Settings Media Type %! $
!$" " ""
" " ! " " # % ! "
Read Settings Media Type %!
! $"# # "!% #$ !#!"
$" " ""
" "
Align Cartridges Print Quality %!
$ !$" " ""
" " ! " " # % ! "
Align Cartridges Print Quality %!
! !#!"
$" " ""
" "
Cancel Replot %! $
!$" " ""
" " ! " " # % ! "
Cancel Replot %!
To Next Page
Loading...
