Media Type
Replot
Print Quality
Form Feed
Roll/Sheet
Continue
Plotting
& #!"&
! # ! # "#
If you clear the calibration parameters, you will then need to perform the plotter
calibrations. (Details chapter 7.) Clearing the EEROM also resets the factory
spittoon value to 0% used. Keep in mind that the value printed on the service
configuration plot may greatly underestimate the amount of ink in the spittoon.
! $"# # !$ !# !#!"
$" " ""
" "
Replot Media Type %! $
!$" " ""
" " ! " " # % ! "
Replot Media Type %!
! $"# # "!% #$ !#!"
$" " ""
" "
Form Feed Print Quality %!
$ !$" " ""
" " ! " " # % ! "
Form Feed Print Quality %!
! !#!"
$" " ""
" "
Roll/Sheet Continue Plotting
%! $ !$" " ""
" " ! " " # % ! "
Roll/Sheet Continue Plotting %!
To Next Page
Loading...
