6Ć48 Removal and Replacement
C4699Ć90000
Removing the Entry Platen
Remove the overdrive enclosure page
6Ć46.
Disconnect the mediaĆsensor cable from
the main PCA (connector labeled
MEDIA).
Remove the indicated screw from the
right sideĆplate.
Torx-15
Remove the indicated two screws from
the left sideĆplate.
Torx-15
Torx-20
Release the indicated entryĆplaten clips
by pushing the bottom front corners of
the entry platen up.
Pull the entry platen horizontally out
from the plotter.
See the following procedure.
To Next Page
Loading...
