6Ć9 Removal and ReplacementC4699Ć90000
Removing the Left EndĆCover
Remove the top cover page 6Ć7.
Remove the rollĆfeed assembly page 6Ć8.
Release the three clips at the bottom of
the endĆcover: first the side clip, then the
front and back clips.
These may be stiff.
Pull the endĆcover up, and remove it from
the plotter.
It's not easy to reinstall the
endĆcovers on the plotter. With some practice,
you should learn the knack. As a guide, before
you replace an endĆcover, take a look at the
various clips on its inside, and identify where
they fit on the plotter.
Make sure that the primer plunger is installed
properly when reinstalling the endĆcover.
To Next Page
Loading...
