6Ć50 Removal and Replacement
C4699Ć90000
There must be no space between the entry
platen and the sideĆplate. It doesn't
matter if there is a small space between
the entry platen and the sideĆplate.
Replace the indicated screw on the
leftĆhand side. ( dogĆpoint screw.)
Tighten this screw, making sure that the
entry platen is aligned tight against the
left sideĆplate.
Torx-15
Replace the indicated screw on the
rightĆhand side. ( dogĆpoint screw.)
Torx-15
Replace the indicated clamping screw on
the leftĆhand side.
Torx-20
Reconnect the mediaĆsensor cable to the
main PCA (connector labeled MEDIA).
Before reinstalling the overdrive
enclosure, ensure that both flags on the
media sensor move freely when you pass a
sheet of media over them.
To Next Page
Loading...
