8Ć7 TroubleshootingC4699Ć90000
Cartridges + Error: One or more of the cartridges missing or making bad
contact.
D Remove each cartridge. Ensure that the protective tape has been removed,
and look for dirty contacts or wear. Replace each cartridge and run the
BlackĆCartridge Alignment Procedure. (Instructions ' User's Guide,
chapter 1.) D Replace the trailing cable. D Replace the carriage.
D Replace the electronics module.
Paper + Error: The current plot is too large and does not fit in memory.
D If the plot is a raster plot, try sending it with a
no negative motion RTL
command. D If it is a vector plot, try using a driver that performs all the
rasterization of the plot in the host computer before sending it to the plotter.
(See also ' chapter 5, w Memory Usage.) D Otherwise, add more memory by
installing a DRAM SIMM.
Cartridges + Ready: The plotter is testing and servicing the cartridges.
Wait.
Ready: The plotter is busy with a task or is receiving a file.
Wait.
Load Media: The plotter has a file in memory, which it is waiting to plot, but
no sheet is loaded.
Load a sheet.
To Next Page
Loading...
