8Ć21 TroubleshootingC4699Ć90000
(and most frequent causes)
(and most frequent causes)
Firmware
A.01.05
Firmware
A.01.04
Firmware
A.01.03
selftest.c 1516 1516 1516 Failure in RAM SIMM test:
RAM SIMM badly connected.
Faulty RAM SIMM.
Faulty electronics module.
selftest.c 1520 1520 1520 Failure in RAM SIMM test:
RAM SIMM badly connected.
Faulty RAM SIMM.
Faulty electronics module.
selftest.c 1563 1563 1563 Failure in Fibis test:
Faulty electronics module.
selftest.c 1567 1567 - Failure in Fibis RAM sequence test:
Faulty electronics module.
selftest.c 1573 1573 1573 Failure in Condor test:
If firmware is revision A.01.02 or
earlier, then change to latest.
Faulty electronics module.
ipc.c 824 824 824 The SPROC did not respond within
10 seconds:
Faulty electronics module.
media_load.c 862
or 889
or 993
or 1310
862
or 889
or 993
or 1310
862
or 889
or 993
or 1310
Bail error or YĆaxis servo error:
Carriage knocked against bail.
Faulty encoder strip.
Faulty trailing cable.
Faulty carriage.
fpmain.c 1489 1489 1489 PCA was initialized in a Designjet
250C and used in a DesignJet 230.
EEROM needs to be reset.
error.c 537 537 537 Processor error:
Faulty electronics module.
To Next Page
Loading...
