8Ć47 TroubleshootingC4699Ć90000
This tests the operation of the cover sensor and the media sensor.
In service mode , press
Sensors Test.
Close the cover of the plotter.
The
Load Media
LED should turn on.
Open the cover.
The
Load Media
LED should turn off.
Insert media into the rightĆhand side of the entry platen.
The
Special Paper
LED should turn on.
Remove the media.
The
Special Paper
LED should turn off.
The LED meanings are summarized as follows:
Cover closed, and
sensor OK
Media present,
and sensor OK
Cover open, or
sensor failed
Media not present,
or sensor failed
Press the Shift key when you want to stop the test.
Sensors Test
Load Media
Special
Paper
Shift
To Next Page
Loading...
