DesignJet 230/250C Service Configuration Plot
Firmware Release: X.XX.XX
SPROC release: X.X
(Servo-Processor Code revision number.)
EEROM Contents
EEROM CONTENTS
(This is for the plotter design engineers to interpret.)
NOTE: All EEPROM Parameters are since last EEROM Reset.
Number of Power Cycles:
(Number of times plotter has been switched on.)
Number of Color Plots:
Number of Black Plots:
Number of Pens:
(Number of times each cartridge has been replaced. Cyan, Magenta, Yellow, Black.)
Factory Spittoon:
(The estimated level of ink in the spittoon. Incorrect if you have cleared the EEROM.)
Number of Bail Errors:
Number of System Errors:
Last System Error:
(To correctly interpret this information, refer to page 8-19.)
Last System Error Data:
(To correctly interpret this information, refer to page 8-19.)
Bench Run:
(Whether the bench run has been performed.)
Bench Run Maximum Y-Axis (Carriage-Axis) PWM:
(This should be less than 102. Typical value = 75.)
Bench Run Maximum X-Axis (Media-Axis) PWM:
(This should be less than 65. Typical value = 52.)
Encoder-Tests Maximum Y-Axis (Carriage-Axis) PWM:
(This should be less than 102. Typical value = 75.)
Encoder-Tests Maximum X-Axis (Media-Axis) PWM:
(This should be less than 65. Typical value = 52.)
Last Accuracy Calibration:
Factory Calibration Factor:
(This is the drive-roller correction factor, calculated during accuracy calibration. It should be approximately 1.
Less than 0.9 means the drive-roller radius is too small. Greater than 1.1 means the drive-roller radius is too big.)
FRONT-PANEL KEYS IN SERVICE MODE 2
To Next Page
Loading...
