Updating System Firmware
D–3
Verify
List
Show
Dump
Verbose
Nverbose
Debug
Ndebug
?
Apu->
4. To update the firmware, type update and either SRM or ARC. (Typing
update ARC will load AlphaBIOS into the flashROM.) The following information
will be displayed as the firmware is being updated. The actual information may
change between versions.
Apu-> update SRM
APU-I *** ROM 0,1 Contents will be destroyed ***
APU-I Are you ready to Program Device? (y/n)y
APU-I Programming device
APU-I Programming device completed
APU-I Programming device
APU-I Programming device completed
Apu->
5. Use the verify command to verify the integrity of the SRM or AlphaBIOS firmware.
First enable verbose mode by typing verbose; then type verify and either
SRM or ARC (for AlphaBIOS).
Apu->
verbose
Apu->
verify SRM
6. To exit the update utility, cycle the power. Leave the power off for at least 20
seconds.
__________________________NOTE ____________________________
Commands such as Dump, List, Show, and Verify must have verbose
mode enabled for their output to be displayed. Type the Verbose command at
the Apu-> prompt to enable verbose mode.
____________________________________________________________
To Next Page
Loading...
