Installing System Options
4–23
Replacing the Battery
The battery supplies power to the real time clock while the system is off. If necessary,
replace the lithium battery with a Panasonic BR2032, CR2032, or equivalent battery.
After replacing the battery, you must verify the system configuration and setup data.
________________________ CAUTION___________________________
If the battery is incorrectly replaced, there is danger of explosion. Replace the
battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to manufacturer's instructions.
____________________________________________________________
________________________ CAUTION___________________________
Take care not to bend the spring that holds down the battery. A bent spring
could result in poor battery contact and intermittent system problems.
____________________________________________________________
1. Gently press down on the battery and push it out sideways, as Figure 4–16 shows.
2. Insert the new battery, positive side up, into the holder.
To Next Page
Loading...
