Installing System Options
4–12
Installing Optional Internal SCSI Storage Devices
The SCSI hard disk drives, CD-ROM, and floppy drives all are located on removable drive
tray brackets. The hard drive brackets are under the CD-ROM drive and the lower section
of the floppy drive tray. This section tells you how to install a hard drive into the
removable drive tray bracket. You can install a maximum of two SCSI hard disk drives in
the internal storage bays.
Installing SCSI Disk Drives
The lower-right-side drive bay (below the CD-ROM drive) contains a drive tray that
accommodates up to two 3.5-inch by 1.0-inch hard disks or one 3.5-inch by 1.6-inch hard
disk. The lower-section floppy drive bay can accommodate one 1.0-inch hard disk. The
maximum total capacity is two drives.
To install an internal SCSI device, follow this procedure:
1. Turn off your system and unplug the power cord from the wall outlet.
2. Unlock and remove the top cover, as described earlier in this chapter.
3. To access the lower-right-side drive bay, remove the CD-ROM drive bracket.
Referring to Figure 4–7, remove the locking pin and push in the button tab
on the
enclosure wall. This releases the CD-ROM drive assembly.
4. Slide the CD-ROM
back (toward the power supply).
To Next Page
Loading...
