Updating System Firmware
D–2
Using the Flash Update Utility from the SRM Console
To update the firmware from the SRM console, do the following:
1. Insert the Firmware Update CD-ROM into the CD-ROM drive.
2. Type the show device command to determine the device ID of the CD-ROM drive.
>>>show device
dka0.0.0.6.0 DKA0 RZ26L 440C
dka400.4.0.6.0 DKA400 TOSHIBA CD-ROM 0064
dva0.0.0.0.1 DVA0
ena0.0.0.1.1 ENA0 08-00-2B-38-67-6B
pka0.7.0.6.0 PKA0 SCSI Bus ID 7
3. Boot the Firmware Update Utility CD-ROM using the device ID display in step 2.
>>>b -fl 0,a0 dka400
Bootfile: [alpha255]as255_vx_x.exe (where x_x is the appropriate
version)
You should see a display similar to the following, while the update utility is loading
and executing:
bootstrap code read in
base = 11e000, image_start = 0, image_bytes = ea800
initializing HWRPB at 2000
initializing page table at 110000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
ff.fe.fd.fc.fb.fa.f9.f8.f7.f6.f5.
ef.df.ee.ed.ec.f4.eb.....ea.e9.e8.e7.e5
X3.7-10895, built on Sep 13 1994 at 11:29:42
>>>Execute Update Sequence
Update Script Complete
(boot pmem:180000 -flags 0,0)
bootstrap code read in
base = 180000, image_start = 0, image_bytes = 800000
initializing HWRPB at 2000
initializing page table at 710000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
apu-version 959328854 *** Firmware Update Utility V2.9 ***
*** System Type: Alpha Workstation 255/233 ***
Update
To Next Page
Loading...
