HP EliteBook 640 G11 - Computer Setup, TPM, and HP Sure Start; Using Computer Setup (BIOS); Restoring Factory Settings in BIOS

a. Disconnect the cable from the ZIF connector (1) on the module. Starting on the left side of the
module, use a tool (2) to release the module, and then remove the module (3). The IR camera
module is available as spare part number N96912-001.
b. IR cameras use different black protective tape depending on the panel. When installing a new
IR camera, be sure to add new tape that matches the shape of the tape on the old camera.
13. To remove an FHD camera module:
■
Starting on the left side of the module, use a tool (1) to release the module. Lift the module (2) up,
and then disconnect the cable from the ZIF connector on the module. The FHD camera module
is available as spare part number N96913-001. The microphone module is available as spare
part number N99998-001.
NOTE: During installation, note that the cable routes under the camera module before it
connects to the module.
14. To remove the ambient light sensor (ALS):
Display assembly
93