■
Disconnect the cable from the ZIF connector (1) on the board, and then use a tool (2) to release
the board from the display. The ALS is available as spare part number N96911-001.
15. To remove the hinges from the display enclosure:
a. Remove the three Phillips M2.0 × 2.0 screws (1) from each hinge.
b. Remove the cables (2) from the left hinge.
c. Remove the cables (3) from the right hinge.
d. Remove the hinges (4) from the display.
The hinges are available as spare part number N96454-001.
16. To remove the display panel/camera cable on models with an IR camera:
a. Disconnect the cable from the ZIF connector (1) on the camera module.
b. Peel the cable (2) off the inside of the display rear cover.
94
Chapter 8 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
