HP EliteBook 860 G9 - Page 72

2. Disconnect the display cable (4), remove the cables from the clips along the side of the WLAN module fan
(5), and remove the cables from the clips along the side of the fan (6).
3. Remove the ve Phillips M2.5 × 5.0 screws (1) that secure the display assembly to the computer.
4. Rotate the display upward to open the hinges (2).
5. Separate the display assembly from the computer (3).
6. If you need to replace display assembly subcomponents:
a. Flex the top (1) and the inside edges of the left and right sides of the bezel (2) to release it.
b. Slide a at tool (3) across the inside of the bottom of the bezel to release it, and then remove the
bezel from the display (4).
64
Chapter 6Removal and replacement procedures for authorized service provider parts