4. Remove the SIM card insert from the computer (1), lift the side of the system board upward (2), and then
pull the system board away from the connectors on the side of the computer to remove it (3).
Reverse this procedure to install the system board.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing theî™»display panel, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 40).
2. Remove the bottom cover (see Bottom cover on page 40).
3. Remove the battery (see Battery on page 41).
Remove the display assembly:
1. Disconnect the webcam cable (1), disconnect the antenna cables from the WWAN module (2), and
remove the cables from the clip (3).
Display assembly 63
To Next Page
Loading...
