HP G3 KVM

Using the on-board Web interface (OBWI) 56
Contact and register an unmanaged switch with a DSView management software device by specifying the
IP address of the management software device.
To configure the device IP address:
1. Click Unit View>Appliance>Appliance Settings>User Accounts>DSView. The Appliance
DSView Settings screen appears.
2. Enter up to four device IP addresses to contact.
3. To disassociate the switch registered with the device, click Disassociate.
4. Click Save.
Closing a KVM session
To close a session:
1. Click Active Sessions. The Active Sessions screen appears.
2. Select the checkbox of the target device.
3. Click Disconnect.
To close a session (local users only):
1. Click Local Session.
2. Select Disconnect Active Session.