3. Edit the configuration file.
FAILOVER_GROUP lan902
STATIONARY_IP 10.0.1.60
# Primary/Standby Interface Priority : Cost
# –––––––––––––––––––––––+–––––––––––––+––––––––––––––––
PRIMARY lan900 8 : 2
STANDBY lan901 7 : 3
Table C-2 lists lan900 events for this example and how proactive failover determines the active
port for lan902.
Table C-2 lan900 Events and Proactive Failover (Unequal Network Costs)
Active Portlan901 Normalized Port
Cost
lan900 Normalized Port
Cost
Event
lan900
2
3/200, or .0152/200, or .010Failover group constructed
1
lan901
3
3/200, or .0152/100, or .020
Port 2 on lan900 is DOWN
lan900
4
3/200, or .0152/200, or .010
Port 2 on lan900 is UP
lan900
5
3/100, or .0302/200, or .010
Port 4 on lan901 is DOWN
lan900
6
3/200, or .0152/200, or .010
Port 4 on lan901 is UP
lan901
7
3/200, or .0150
Ports 2 and 3 on lan900 are
DOWN
1 All ports in the link aggregates are operational.
2
Normalized port cost is lower than lan901.
3
Normalized port cost is lower than lan900.
4
Normalized port cost is lower than lan901.
5
Normalized port cost is lower than lan901.
6
Normalized port cost is lower than lan901.
7
This behavior is the same as if lan902 were a priority-based failover group.
104 Configuring HP APA by editing files
To Next Page
Loading...
