HP HP-UX 11i v3

Figure 3-8 Sample Failover Group Using Link Aggregates Configuration
LAN Monitor failover
group using HP APA
link aggregations.
PowerRun Attn. Fault Remote
Active
LinkAgg
Standby
LinkAgg
Active
LinkAgg
Standby
hp ProCurve
Switch 8000
hp ProCurve
Switch 8000
LAN Monitor failover
group using an HP APA
link aggregation as the
active link and one
physical link as a
standby link.
PowerRun Attn. Fault Remote
hp ProCurve
Switch 8000
hp ProCurve
Switch 8000
Preparing for configuration
Before you configure the HP APA software, you must gather information about your system
and network environment. Figure 3-9 shows the APA Configuration Worksheet. The following
sections describe the information that you need to record on the worksheets. If you are viewing
this manual on line, you can use the print feature to print a copy of this worksheet.
Preparing for configuration 29