EasyManuals Logo

HP HP-UX 11i v3 User Manual

HP HP-UX 11i v3
125 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
1. Click Create Failover Group on the APA main page to open the Create Failover Group
page as shown in Figure 3-12.
Figure 3-12 Create Failover Group Page
2. Select a Link Aggregate Instance, or accept the default. If you select a different value, the
display refreshes.
3. Select a Failover Policy, if you do not want to accept the default. If you select a different
value, the display refreshes.
4. Select the ports to include in the failover group.
NOTE: Before adding ports to a failover group, you must check link connectivity between
the ports.
5. Enter a Priority, if you are creating a failover group with a priority-based failover policy.
6. Enter a Cost, if you are creating failover group with a cost-based failover policy.
7. Click Advanced Parameters to display additional failover group parameters.
Enter the failover group parameters you want.
8. Select the Configuration Options you want.
9. Click OK to create a failover group and set the attributes. An Operation Successful page
appears, confirming the creation of the failover group and the updating of the APA
configuration.
10. Click OK. The APA main page displays, showing the newly created failover group.
By default, SMH changes the current APA configuration and saves the information and APA
configuration to the /etc/rc.config.d/hp_apaconf, /etc/rc.config.d/
36 Configuring APA

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP HP-UX 11i v3 and is the answer not in the manual?

HP HP-UX 11i v3 Specifications

General IconGeneral
BrandHP
ModelHP-UX 11i v3
CategorySoftware
LanguageEnglish

Related product manuals