2. Configure HP APA. Do the following:
a. Unplug all LAN connections to be aggregated.
b. Create the aggregations. They must be either 2 or 4 port trunks. For two-port
aggregations, the beginning port number must be odd. For four-port aggregations, the
beginning port number must be a number divisible by 4 plus 1 (for example, 1, 5, 9, 13).
Use the following command to create a four-port aggregation:
HP9304(config)#trunk server e 1/5 to 1/8
c. Save the configuration. Enter:
HP9304(config)#write mem
d. Reboot the switch. Enter the following:
HP9304(config)#exit
HP9304#reload
e. After switch reboots, plug in the cables and display the trunk configuration as follows:
HP9304>show trunk
Information similar to the following displays:
Configured trunks:
Trunk Type Ports
3 Server 1/5 1/6 1/7 1/8
5 Server 1/9 1/10 1/11 1/12
17 Server 2/1 2/2
19 Server 2/5 2/6
20 Server 2/7 2/8
21 Server 2/9 2/10
Operational trunks:
Trunk Type Ports Duplex Speed Tag Priority
3 Server 1/5 1/6 1/7 1/8 Full 100M No level0
5 Server 1/9 1/10 1/11 1/12 Full 100M No level0
17 Server 2/1 2/2 Full 100M No level0
19 Server 2/5 2/6 Full 100M No level0
20 Server 2/7 2/8
21 Server 2/9 2/10 Full 100M No level0
To remove the trunk in the previous example, enter the following:
no trunk server e 1/5 to 1/8
118 Switch configuration information
To Next Page
Loading...
