1 MANUAL mode: Can be Load Balancing or Non-Load Balancing
• Load Balancing: MAC, IP, or LB_PORT algorithm
• Non–Load Balancing: Hot Standby mode
2 Load Balancing is configurable for outbound traffic on Ethernet links only.
3 Links must be of the same speed and type (100Base-T or 1000Base-T).
4 LACP requires full duplex (FD) operation of the links.
5 You cannot reset the speed, duplex mode, or MTU size over a link aggregate.
6 This is for the total of link aggregates and failover groups combined.
88 Product specifications
To Next Page
Loading...
