Removal and replacement procedures 41
If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.
To replace the component, reverse the removal procedure.
Four-bay LFF non-hot-plug drive backplane
To remove the component:
1. If installed, remove the security bezel ("Remove the security bezel (optional)" on page 29).
2. Power down the server (on page 30).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 33).
5. Remove the access panel ("Access panel" on page 40).
6. Remove all non-hot-plug drives.
7. Disconnect all cables connected to the drive backplane.
To Next Page
Loading...
