HP HPE ProLiant DL120 Gen9 - Removing a DIMM

Removal and replacement procedures 54
Populated DIMM speed with Intel Xeon E5-2600 v4 processor installed
Type Rank
1 DIMM per channel
(MT/s)
2 DIMMs per
channel (MT/s)
RDIMM
Single
2400
2133
RDIMM
Dual
2400
2133
LRDIMM
Dual
2400
2400
Maximum memory capacity
Maximum memory capacity is a function of DIMM capacity, number of installed DIMMs, memory type, and
number of installed processors.
Maximum memory capacity with Intel Xeon E5-2600 v3 processor installed
DIMM type DIMM rank Capacity (GB)
Maximum capacity
(GB)
RDIMM
Single-rank
4
32
RDIMM
Single-rank
8
64
RDIMM
Dual-rank
8
64
RDIMM
Dual-rank
16
128
LRDIMM
Dual-rank
16
128
RDIMM
Dual-rank
32
256
LRDIMM
Quad-rank
32
256
Maximum memory capacity with Intel Xeon E5-2600 v4 processor installed
DIMM type DIMM rank Capacity (GB)
Maximum capacity
(GB)
RDIMM
Single-rank
8
64
RDIMM
Single-rank
16
128
RDIMM
Dual-rank
16
128
RDIMM
Dual-rank
32
256
LRDIMM
Dual-rank
32
256
Removing a DIMM
To remove the component:
1. Power down the server (on page 30).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 33).
4. Remove the access panel ("Access panel" on page 40).
5. Remove any expansion board installed in slot 1 and 2. ("Expansion board" on page 61)
6. Open the DIMM slot latches.