Removal and replacement procedures 66
6.
Remove the FlexibleLOM riser cage.
7. Remove the FlexibleLOM adapter from the riser cage.
To replace the component, reverse the removal procedure.
GPU
To remove the component:
1. Power down the server (on page 30).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 33).
4. Remove the access panel ("Access panel" on page 40).
To Next Page
Loading...
