Removal and replacement procedures 46
a.
Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 33).
4. Remove the access panel ("Access panel" on page 40).
5. Remove the PCI riser cage (on page 35).
6. Disconnect the SATA cables from the M.2 SSD enablement board.
7. Remove the M.2 SSD enablement board.
o Slot 2
o Slot 3
To replace the component, reverse the removal procedure.
M.2 SSD module
To Next Page
Loading...
