Removal and replacement procedures 69
4.
Do one of the following:
o Slide the server into the rack.
o Install the server into the rack.
5. Power up the server.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Front I/O module
To remove the component:
1. If installed, remove the security bezel ("Remove the security bezel (optional)" on page 29).
2. Power down the server (on page 30).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 33).
5. Remove the access panel ("Access panel" on page 40).
6. Remove the front I/O module.
a. Disconnect the front I/O module from the system board.
b. Detach the ambient thermal sensor cable from its clip.
c. Remove the screws and disconnect the front I/O module connectors from the front panel.
— Four-bay LFF drive model
To Next Page
Loading...
