Removal and replacement procedures 65
8.
Remove the riser board from the cage.
To replace the component, reverse the removal procedure.
FlexibleLOM riser assembly
To remove the component:
1. Power down the server (on page 30).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 30).
o Remove the server from the rack (on page 33).
4. Remove the access panel ("Access panel" on page 40).
5. Disconnect all cables connected to existing expansion boards.
To Next Page
Loading...
