Removal and replacement procedures 42
8.
Remove the non-hot-plug drive backplane.
To replace the component, reverse the removal procedure.
Four-bay LFF hot-plug drive backplane
To remove the component:
1. If installed, remove the security bezel ("Remove the security bezel (optional)" on page 29).
2. Power down the server (on page 30).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Extend or remove ("Remove the server from the rack" on page 33) the server from the rack.
5. Remove the access panel ("Access panel" on page 40).
6. Remove all hot-plug hard drives.
7. Disconnect all cables connected to the drive backplane.
To Next Page
Loading...
