Chapter 2
Installing the System
Cabling and Powering On the Server
89
The MP Main Menu is displayed:
Figure 2-33 MP Main Menu
Configuring LAN Information for the MP
This section describes how to set and verify the server management processor (MP) LAN port information.
LAN information includes the MP network name, the MP IP address, the subnet mask, and gateway address.
This information is provided by the customer.
To set the MP LAN IP address:
Step 1. At the MP Main Menu prompt (MP>), enter cm.
NOTE If the Command Menu does not appear, enter q to return to the MP Main Menu, then
enter cm..
Step 2. From the MP Command Menu prompt (MP>CM:), enter lc (for LAN configuration).
The screen displays the default values and asks if you want to modify them. It is a good idea to
write down the information or log it to a file, because it may be required for future troubleshooting.
To Next Page
Loading...
Need help?
General