2-18
Installing the Switch
Installation Procedures
Installing the Switch
Wall mounting the Series 2600-8-PWR Switch
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.
2. Attach the switch to the wall or wood surface with two 5/8-inch number
12 wood screws (not included).
Caution The 2600-8-PWR switch can only be wall mounted either with the RJ-45 ports
side up or down (horizontally). A vertical wall mount orientation is not
supported.
For “Flat” Wall Mounting (Horizontal)
M4 screws
5/8-inch
wood screws
Wall
RJ-45 Ports
To Next Page
Loading...
