4-66
Web and MAC Authentication
Configuring MAC Authentication on the Switch
Figure 4-40. Example of show port-access mac-based Command Output
Figure 4-41. Example of show port-access mac-based clients Command Output
HP Switch(config)# show port-access mac-based
Port Access MAC-Based Status
Auth Unauth Untagged Tagged Port % In RADIUS
Port Clients Clients VLAN VLANs COS Limit ACL
---- ------- ------- -------- ------ -------- ------ ------
1 1 1 2003 Yes 70000000 100 Yes
2 2 0 MACbased No Yes Yes Yes
3 4 0 1 Yes No No No
Syntax: show port-access mac-based clients [port-list]
Displays the session status, name, and address for each
MAC-authenticated client on the switch. The IP address
displayed is taken from the DHCP binding table (learned
through the DHCP Snooping feature).
If DHCP snooping is not enabled on the switch, n/a (not
available) is displayed for a client’s IP address.
If a MAC-authenticated client uses an IPv6 address, n/a - IPv6
is displayed.
If DHCP snooping is enabled but no MAC-to-IP address
binding for a client is found in the DHCP binding table, n/a
- no info is displayed.
HP Switch(config)# show port-access mac-based clients
Port Access MAC-Based Client Status
Port MAC Address IP Address Session Status
---- ----------- --------------------------------------- -------------
1 001321-eb8063 2001:fecd:ba23:cd1f:dcb1:1010:9234:4088 unauthenticated
1 000000-111112 192.192.192.192 authenticated
2 000000-111111 n/a authenticating
To Next Page
Loading...
Need help?
General
