HP J8697A User Manual

8-35
Configuring Secure Shell (SSH)
SSH Client and Secure Sessions
Copying the SSH Client Known Hosts File to
Another Location
The SSH client known hosts file can be copied to a location on a remote device
using the commands below. If the file already exists on the remote device, you
are prompted for confirmation before overwriting the file:
Warning: The remote file will be overwritten, continue
[y/n] ?
IPv4: Specifies the TFTP server’s IPv4 address.
IPv6: Specifies the TFTP server’s IPv6 address.
<filename>: The remote filename containing the key.
[append]: Append hosts to the existing ssh-client-known-
hosts file.
Default: Replace the existing known hosts file.
Syntax: copy ssh-client-known-hosts sftp [user <username> | <username@>]
<hostname | IPv4 | IPv6> <filename>
copy ssh-client-known-hosts tftp <hostname | IPv4 | IPv6> <filename>
copy ssh-client-known-hosts <filename> usb
copy ssh-client-known-hosts xmodem
Copies the SSH client known hosts file to another location.
ssh-client-known-hosts: The known hosts file.
[user <username | username@>]: Optional; there must be
configured usernames for Operator and Manager.
If no username is specified, the client’s current username
is used. There will be a prompt for a password if needed.
hostname: Specifies the hostname of the TFTP server.
IPv4: Specifies the TFTP server’s IPv4 address.
IPv6: Specifies the TFTP server’s IPv6 address.
<filename>: The remote filename containing the key.

HP J8697A Specifications

General

Ports	24
Form Factor	Rack-mountable
Power Supply	Internal
Management	Managed
VLAN Support	Yes
Jumbo Frame Support	Yes
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Model	HP J8697A
Port Type	10/100/1000BASE-T
Layer	Layer 2