HP J8697A User Manual

11-11
Configuring Advanced Threat Protection
DHCP Snooping
Changing the Remote-id from a MAC to an IP Address
By default, DHCP snooping uses the MAC address of the switch as the remote-
id in Option 82 additions. The IP address of the VLAN the packet was received
on or the IP address of the management VLAN can be used instead by entering
this command with the associated parameter:
HP Switch(config)# dhcp-snooping option 82 remote-id
<mac|subnet-ip|mgmt-ip>
Figure 11-6. Example of DHCP Snooping Option 82 using the VLAN IP Address
Disabling the MAC Address Check
DHCP snooping drops DHCP packets received on untrusted ports when the
check address (chaddr) field in the DHCP header does not match the source
MAC address of the packet (default behavior). To disable this checking, use
the no form of this command.
HP Switch(config)# dhcp-snooping verify mac
HP Switch(config)# dhcp-snooping option 82 remote-id subnet-
ip
HP Switch(config)# show dhcp-snooping
DHCP Snooping Information
DHCP Snooping : Yes
Enabled Vlans : 4
Verify MAC : Yes
Option 82 untrusted policy : drop
Option 82 Insertion : Yes
Option 82 remote-id : subnet-ip

HP J8697A Specifications

General

Ports	24
Form Factor	Rack-mountable
Power Supply	Internal
Management	Managed
VLAN Support	Yes
Jumbo Frame Support	Yes
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Model	HP J8697A
Port Type	10/100/1000BASE-T
Layer	Layer 2