HP J8697A User Manual

10-96
IPv4 Access Control Lists (ACLs)
Editing an Existing ACL
Figure 10-31. Example of Overwriting One Remark with Another
HP Switch(config)# ip access-list standard Accounting
HP Switch(config-std-nacl)# permit host 10.10.10.115
HP Switch(config-std-nacl)# deny 10.10.10.1/24
HP Switch(config-std-nacl)# remark Marketing
HP Switch(config-std-nacl)# remark Channel_Mktg
HP Switch(config-std-nacl)# show run
.
.
.
ip access-list standard "Accounting"
10 permit 10.10.10.115 0.0.0.0
20 deny 10.10.10.1 0.0.0.255
30 remark "Channel_Mktg"
exit
Where multiple remarks are
sequentially entered for
automatic inclusion at the end of
an ACL, each successive remark
replaces the previous one until an
ACE is configured for automatic
inclusion at the end of the list.

HP J8697A Specifications

General

Ports	24
Form Factor	Rack-mountable
Power Supply	Internal
Management	Managed
VLAN Support	Yes
Jumbo Frame Support	Yes
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Model	HP J8697A
Port Type	10/100/1000BASE-T
Layer	Layer 2