HP J8697A User Manual

13-60
Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
Figure 13-14.Example of show port-access authenticator session-counters Command
Syntax: show port-access authenticator session-counters [port-list]
Displays information for active 802.1X authentication ses-
sions on all switch ports or specified ports that are enabled
as 802.1X authenticators, including:
• 802.1X frames received and transmitted on each port
• Duration and status of active 802.1X authentication
sessions (in-progress or terminated)
• User name of 802.1X supplicant included in 802.1X
response packets, configured with the aaa port-access
supplicant identity <username> command (see page 13-49).
802.1X configuration information for ports that are not
enabled as an 802.1X authenticators is not displayed.
HP Switch(config)# show port-access authenticator session-counters
Port Access Authenticator Session Counters
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
Session Session
Port Frames In Frames Out Time(sec.) Status User
---- ---------- ----------- ----------- ----------- -------
2 45623 45623 20 in-progress bert

HP J8697A Specifications

General

Ports	24
Form Factor	Rack-mountable
Power Supply	Internal
Management	Managed
VLAN Support	Yes
Jumbo Frame Support	Yes
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Model	HP J8697A
Port Type	10/100/1000BASE-T
Layer	Layer 2