EN Managing logs and reports 51
Setting when the T.30 protocol trace report
prints
You can set the T.30 protocol trace report to print:
l Never (the default)
l If an error occurs
l At the end of every send and received fax
To set when the T.30 protocol trace reports prints
1 Press ENTER/MENU.
2 Use the < or > key to select
SERVICE and press ENTER/MENU.
3 Use the < or > key to select
PRINT T.30 TRACE and press
E
NTER/MENU.
4 Use the < or > key to select the option for when you want the T.30
protocol trace report to print.
5 Press E
NTER/MENU to save the selection.
To Next Page
Loading...
