HP LaserJet 3200 - Changing the detect dial tone setting

EN Advanced send fax features and settings 85
Changing the detect dial tone setting
Normally the product waits for a dial tone before attempting to a dial a
fax number. If you are using the product on the same line as your
phone, turn on the detect dial tone setting. This will prevent the
product from sending a fax while someone is on the phone. In
Australia, this setting by default is set to Off.
To change detect dial tone
1 Press ENTER/MENU.
2 Use the < or > key to select
FAX SETUP and then press ENTER/
M
ENU.
3 Press > once to select
FAX SEND SETUP and then press ENTER/
M
ENU.
4 Use the < or > key to select
DETECT DIAL TONE and then press
E
NTER/MENU.
5 Use the < or > key to select
ON or OFF and then press ENTER/
M
ENU.