Category Substrate name Available print modes
Generic Backlit Paper 12p_6C_130 16p_6C_150 20p_6C_150
PP & PE film & banner Generic PP & PE Synthetics 12p_6C_80 16p_6C_80 20p_6C_90
Generic Backlit PP & PE Synthetics 12p_6C_130 16p_6C_130 20p_6C_150
PET film Generic Polyester Film 6p_4C_80 8p_6C_100 10p_6C_110
Generic Backlit Polyester Film 12p_6C_170 16p_6C_185 20p_6C_200
Textile Generic Textile 12p_6C_200 16p_6C_200 20p_6C_230
Generic Canvas & Coated Textile 10p_6C_110 12p_6C_110
Key
●
XXp: Number of passes
●
XXC: Number of colors
●
XXX: Ink density
NOTE: More specific settings for many substrates from different vendors are available in the HP Substrate
Finder at
http://www.hp.com/go/latexmediafinder/.
NOTE: After selecting the number of passes in the Add New Print Mode screen, make sure to reset your
print mode to default category values for that print mode.
Tips
●
2 to 4 passes provide lower print quality. Also, the color gamut will be slightly reduced, as total ink is
limited to allow for curing.
●
1200 dpi print resolution is available in the 18-pass print mode only. If you intend to use it, ensure that
you have a specific substrate preset for this print mode, because reusing others may not deliver the
expected print quality.
●
For fast layout proofing on low-cost substrates, a low-ink 2-pass print mode has been enabled. It is
recommended for paper-based substrates only, as curing may not work correctly for other substrate
types in this mode.
Delete a substrate preset
You can delete substrate presets that you have added yourself, but not those that were supplied with the
printer.
To do so, just press the
icon in the Substrate Library screen.
96 Chapter 4 Substrate settings ENWW
To Next Page
Loading...
