Check the file system
It is possible to check the integrity of the file system on the printer's hard disk, and automatically correct any
errors. You are recommended to do this about once every six months, or if you notice any trouble in
accessing files on the hard disk.
To execute the file system check, go to the front panel and press
, then Preventive maint. tasks > File
system check.
If the printer is aware of damage to the file system, for instance after a severe software problem, it may start
a file system check automatically. This can take about ten minutes.
Printer alerts
The printer can communicate two types of alerts:
●
Errors: When the printer is unable to print.
●
Warnings: When the printer needs attention for an adjustment, such as a calibration, preventive
maintenance, or ink cartridge replacement.
●
Advice: When a firmware update is available or the downloaded firmware is ready to be installed.
Printer alerts appear in the front panel and in the Embedded Web Server.
●
Front-panel display: The front panel shows the alerts in the upper left part of the screen (notification
bar).
Only one alert is shown at a time. If you press the notification bar, all the current printer alerts are
shown. The list of alerts can be folded back by pressing or sliding up the bottom row of the list.
Clicking an alert opens the application that could help to resolve it. Firmware update advice is dismissed
when entering the Printer application. Once dismissed, there won’t be any reminder later on about the
ENWW The front panel 17
To Next Page
Loading...
Need help?
General
