3 Handle the substrate and troubleshoot
substrate issues
●
Overview
●
Porous substrates
●
Load a roll onto the spindle
●
Load a roll into the printer
●
The ink collector (360 only)
●
The loading accessory (360 only)
●
Assisted manual load
●
The edge holders
●
Load a cut sheet into the printer
●
Unload a roll from the printer
●
The take-up reel
●
Double-sided printing (360 only)
●
View information about the substrate
●
Change substrate width and right edge position
●
Substrate length tracking
●
Cut substrate (360 only)
●
Bypass job start safety
●
Store the substrate
●
The substrate cannot be loaded successfully
●
The substrate is mispositioned
●
The substrate has jammed
●
The substrate is deformed or wrinkled
●
The substrate has shrunk or expanded
●
The substrate has bow deformation
●
The automatic cutter does not work (360 only)
38 Chapter 3 Handle the substrate and troubleshoot substrate issues ENWW
To Next Page
Loading...
