To Next Page

To Previous Page

2. Click Clone to clone the preset, and enter a name for the new preset.

Modify a substrate preset

You can modify a preset by pressing Modify.

Then click the

icon of the print mode that you want to modify; or click Add new print mode. You can

delete or change the name of any print mode; although you should keep at least one print mode.

NOTE: You can define up to six print modes.

NOTE: The number of passes in an existing print mode cannot be changed. If you want to change the

number of passes, create a new print mode.

NOTE: You are not allowed to create two print modes with the same number of passes, the same efficiency

mode, and the same color saturation.

To change the values, you must print a test plot. Check it and choose the number in the pull-down color-

saturation menu that matches your preferences in terms of curing and drying. If none of the options are good

enough, try changing the temperature and reprint. You can also change the substrate advance settings.

ENWW Modify a substrate preset 91

Brand

Model

Latex 300 Series

HP Latex 300 Series User Guide

Other manuals for HP Latex 300 Series