10. Lock the blue stop when it is in contact with the substrate.
11. Insert the spindle carefully into the printer.
WARNING! Avoid trapping your fingers between the spindle and the spindle supports.
Risk of trapped fingers
For more safety information, please see
Safety precautions on page 3
CAUTION: Ensure that the sliders in the loading table are under the left hub, otherwise the spindle will
not enter correctly into the left spindle support, and could fall on the floor.
If you regularly use different substrates, you can change rolls more quickly if you pre-load rolls of different
substrates on different spindles. Extra spindles are available for purchase.
ENWW Load a roll onto the spindle 49
To Next Page
Loading...
