●
Skew acceptance: The available values are between 1 and 5, default 3. The printer warns you if the
skew is over the limit you have set, but you can still choose to continue loading.
●
Length tracking: If you check the box and give the length of your roll, the printer reduces the spare
paper when printing and tells you the remaining length. See
Substrate length tracking
on page 78.
●
Double-sided: May be Off, Side A, or Side B. See
Double-sided printing (360 only) on page 75.
●
Print zone: Choose Platen or Ink collector. See
The ink collector (360 only) on page 53.
●
Use loading accessory. See
The loading accessory (360 only) on page 58.
●
Assisted manual load. See
Assisted manual load on page 61.
●
Use edge holders. See
The edge holders on page 63.
When you have made your choices, instructions are displayed.
3. Carefully insert the leading edge of the substrate above the smooth black roller, making sure the
substrate remains taut during the process. Avoid rewinding the substrate manually, unless the printer
asks you to do so.
WARNING! Take care not to insert your fingers inside the printer's substrate path.
The printer beeps when it detects and accepts the leading edge of the substrate.
ENWW Load a roll into the printer 51
To Next Page
Loading...
