4. Try to move the printhead carriage out of the way.
5. Lift the substrate pinch lever as far up as it will go.
6. Carefully remove as much as possible of the jammed substrate from the top of the printer. Cut the
substrate if necessary.
CAUTION: Try to avoid pulling the substrate out through the input path, because this reverses the
normal direction of movement, and could damage printer parts.
WARNING! Do not touch the printer's curing enclosure, which could be hot.
Risk of burns
For more safety information, please see
Safety precautions on page 3
ENWW The substrate has jammed 81
To Next Page
Loading...
