Base enclosure
Description Spare part number
Base enclosure 738681-001
Before removing the bottom cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 32).
5. Remove the service door (see
Service door on page 33).
Remove the base enclosure:
1. Position the computer upside down, with the battery bay facing you.
2. Remove the two front rubber screw covers (1) and (2), the one screw cover (3) on the middle left
edge, the four back rubber screw covers (4), (5), and (6), and the two back panel screw covers
(7).
Component replacement procedures 55
To Next Page
Loading...
