HP office jet 6950 - Set the redial options; Set the fax speed

To set the dial type
1. From the printer control panel display, touch Fax .
2. Touch Setup , and then touch Preferences .
3. Touch Dial Type.
4. Touch to select Tone or Pulse.
Set the redial options
If the printer was unable to send a fax because the receiving fax machine did not answer or was busy, the
printer attempts to redial based on the settings for the redial options. Use the following procedure to turn the
options on or o.
●
Busy redial: If this option is turned on, the printer redials automatically if it receives a busy signal. The
default is On .
●
No answer redial: If this option is turned on, the printer redials automatically if the receiving fax
machine does not answer. The default is O .
●
Connection problem redial: If this option is turned on, the printer redials automatically if there has been
a problem connecting with the receiving fax machine. Connection problem redial works only for sending
faxes from memory. The default is On .
To set the redial options
1. From the printer control panel display, touch Fax .
2. Touch Setup , and then touch Preferences .
3. Touch Auto Redial .
4. Touch Busy Redial , No Answer Redial , or Connection Problem Redial to switch it on or o.
Set the fax speed
You can set the fax speed used to communicate between your printer and other fax machines when sending
and receiving faxes.
If you use one of the following, setting the fax speed to a slower speed might be required:
●
An Internet phone service
●
A PBX (private branch exchange) system
●
Fax on Voice over Internet Protocol (VoIP)
●
An integrated services digital network (ISDN) service
If you experience problems sending and receiving faxes, try using a slower Speed . The following table
provides the available fax speed settings.
Fax speed setting
Fax speed
Fast v.34 (33600 bps)
Medium v.17 (14400 bps)
Slow v.29 (9600 bps)
ENWW Change fax settings 51